Maths-
General
Easy

Question

The curvesblank x to the power of 2 end exponent minus y to the power of 2 end exponent equals 5 blankandblank fraction numerator x to the power of 2 end exponent over denominator 18 end fraction plus fraction numerator y to the power of 2 end exponent over denominator 8 end fraction equals 1 blankcut each other at the common point at an angle

  1. fraction numerator pi over denominator 4 end fraction    
  2. fraction numerator pi over denominator 3 end fraction    
  3. fraction numerator pi over denominator 2 end fraction    
  4.    

The correct answer is: fraction numerator pi over denominator 2 end fraction


    Point of intersection for two curves is (3, 2) andblank m subscript 1 end subscript equals fraction numerator 3 over denominator 2 end fraction comma m subscript 2 end subscript equals fraction numerator negative 2 over denominator 3 end fraction

    Related Questions to study

    General
    maths-

    The area of the triangle formed by the tangent to the curveblank y equals fraction numerator 8 over denominator 4 plus x to the power of 2 end exponent end fraction blankat x=2 on it and the axes is

    The area of the triangle formed by the tangent to the curveblank y equals fraction numerator 8 over denominator 4 plus x to the power of 2 end exponent end fraction blankat x=2 on it and the axes is

    maths-General
    General
    maths-

    If the normal line at (1, -2) on the curveblank y to the power of 2 end exponent equals 5 x minus 1 blankis ax - 5y + b = 0 then the values of a and b are

    If the normal line at (1, -2) on the curveblank y to the power of 2 end exponent equals 5 x minus 1 blankis ax - 5y + b = 0 then the values of a and b are

    maths-General
    General
    maths-

    If the curveblank y equals p x to the power of 2 end exponent plus q x plus r blankpasses through the point (1,2) and the line y = x touches it at the origin, then the values of p,q and r are

    If the curveblank y equals p x to the power of 2 end exponent plus q x plus r blankpasses through the point (1,2) and the line y = x touches it at the origin, then the values of p,q and r are

    maths-General
    parallel
    General
    maths-

    The curveblank x to the power of 4 end exponent minus 2 x y to the power of 2 end exponent plus y to the power of 2 end exponent plus 3 x minus 3 y equals 0 blankcuts the x-axis at (0,0) at an angle

    The curveblank x to the power of 4 end exponent minus 2 x y to the power of 2 end exponent plus y to the power of 2 end exponent plus 3 x minus 3 y equals 0 blankcuts the x-axis at (0,0) at an angle

    maths-General
    General
    maths-

    The angle between x-axis and the tangent to the curveblank y equals 6 plus x minus x to the power of 2 end exponent text  at  end text left parenthesis 2 , 4 right parenthesis blankis

    The angle between x-axis and the tangent to the curveblank y equals 6 plus x minus x to the power of 2 end exponent text  at  end text left parenthesis 2 , 4 right parenthesis blankis

    maths-General
    General
    physics-

    A particle of mass m moving horizontally with v0 strikes a smooth wedge of mass M, as shown in figure. After collision, the ball starts moving up the inclined face of the wedge and rises to a height h. When the particle has risen to a height h on the wedge, then choose the correct alternative(s)

    A particle of mass m moving horizontally with v0 strikes a smooth wedge of mass M, as shown in figure. After collision, the ball starts moving up the inclined face of the wedge and rises to a height h. When the particle has risen to a height h on the wedge, then choose the correct alternative(s)

    physics-General
    parallel
    General
    physics-

    In a one dimensional collision between two identical particles A and B, B is stationary and A has momentum p before impact. During impact, B gives impulse J to A

    In a one dimensional collision between two identical particles A and B, B is stationary and A has momentum p before impact. During impact, B gives impulse J to A

    physics-General
    General
    physics-

    A ball of mass m collides elastically with an identical ball at rest with some impact parameter

    A ball of mass m collides elastically with an identical ball at rest with some impact parameter

    physics-General
    General
    physics-

    A spring block system is placed on a rough horizontal floor. The block is pulled towards right to give spring some elongation and released

    A spring block system is placed on a rough horizontal floor. The block is pulled towards right to give spring some elongation and released

    physics-General
    parallel
    General
    physics-

    A block of mass m slides down a plane inclined at an angle theta. Which of the following will NOT increase the energy lost by the block due to friction?

    A block of mass m slides down a plane inclined at an angle theta. Which of the following will NOT increase the energy lost by the block due to friction?

    physics-General
    General
    physics-

    Imagine a situation in which the horizontal surface of block M0 is smooth, and its vertical surface is rough with a coefficient of friction mu. Consider a special situation in which both the faces of the block M0 are smooth, as shown in adjoining figure. Mark out the correct statement(s)

    Imagine a situation in which the horizontal surface of block M0 is smooth, and its vertical surface is rough with a coefficient of friction mu. Consider a special situation in which both the faces of the block M0 are smooth, as shown in adjoining figure. Mark out the correct statement(s)

    physics-General
    General
    physics-

    A block of mass M is placed on a horizontal surface and it is tied with an inextensible string to a block of mass, as shown in figure. A block of mass m0 is also placed on M. If friction force exists between the block M and the block m0 and not between the block M and the horizontal surface, then the minimum value of mu for which the block m remains stationary is

    A block of mass M is placed on a horizontal surface and it is tied with an inextensible string to a block of mass, as shown in figure. A block of mass m0 is also placed on M. If friction force exists between the block M and the block m0 and not between the block M and the horizontal surface, then the minimum value of mu for which the block m remains stationary is

    physics-General
    parallel
    General
    physics-

    A block of mass M is placed on a horizontal surface and it is tied with an inextensible string to a block of mass, as shown in figure. A block of mass m0 is also placed on M. If mu subscript 0 end subscript be the coefficient of friction between the block M and the horizontal surface then the minimum value of m0 required to keep the block m stationary is

    A block of mass M is placed on a horizontal surface and it is tied with an inextensible string to a block of mass, as shown in figure. A block of mass m0 is also placed on M. If mu subscript 0 end subscript be the coefficient of friction between the block M and the horizontal surface then the minimum value of m0 required to keep the block m stationary is

    physics-General
    General
    physics-

    A block of mass M is placed on a horizontal surface and it is tied with an inextensible string to a block of mass, as shown in figure. A block of mass m0 is also placed on M. In previous problem, the tension in the string will be

    A block of mass M is placed on a horizontal surface and it is tied with an inextensible string to a block of mass, as shown in figure. A block of mass m0 is also placed on M. In previous problem, the tension in the string will be

    physics-General
    General
    physics-

    A block of mass M is placed on a horizontal surface and it is tied with an inextensible string to a block of mass, as shown in figure. A block of mass m0 is also placed on M. The minimum value of mu for which the block m remains stationary is

    A block of mass M is placed on a horizontal surface and it is tied with an inextensible string to a block of mass, as shown in figure. A block of mass m0 is also placed on M. The minimum value of mu for which the block m remains stationary is

    physics-General
    parallel

    card img

    With Turito Academy.

    card img

    With Turito Foundation.

    card img

    Get an Expert Advice From Turito.

    Turito Academy

    card img

    With Turito Academy.

    Test Prep

    card img

    With Turito Foundation.