Physics-
General
Easy

Question

Both the blocks shown here are of mass m and are moving with constant velocity in direction shown in a resistive medium which exerts equal constant force on both blocks in direction opposite to the velocity. The tension in the string connecting both of them will be : (Neglect friction)

  1. mg    
  2. mg/2    
  3. mg/3    
  4. mg/4    

The correct answer is: mg/2

Related Questions to study

General
physics-

Equal force F (> mg) is applied to string in all the 3 cases. Starting from rest, the point of application of force moves a distance of 2 m down in all cases. In which case the block has maximum kinetic energy?

Equal force F (> mg) is applied to string in all the 3 cases. Starting from rest, the point of application of force moves a distance of 2 m down in all cases. In which case the block has maximum kinetic energy?

physics-General
General
physics-

What should be the minimum force P to be applied to the string so that block of mass m just begins to move up the frictionless plane

What should be the minimum force P to be applied to the string so that block of mass m just begins to move up the frictionless plane

physics-General
General
physics-

A truck starting from rest moves with an acceleration of 5 m/s2 for 1 sec and then moves with constant velocity. The velocity w.r.t ground v/s time graph for block in truck is (Assume that block does not fall off the truck)

A truck starting from rest moves with an acceleration of 5 m/s2 for 1 sec and then moves with constant velocity. The velocity w.r.t ground v/s time graph for block in truck is (Assume that block does not fall off the truck)

physics-General
parallel
General
physics-

If position time graph of a particle is sine curve as shown, what will be its velocity-time graph.

If position time graph of a particle is sine curve as shown, what will be its velocity-time graph.

physics-General
General
physics-

Six identical conducting rods are joined as shown in figure. Points A and D are maintained at temperature of 200°C and 20°C respectively. The temperature of junction B will be:

Six identical conducting rods are joined as shown in figure. Points A and D are maintained at temperature of 200°C and 20°C respectively. The temperature of junction B will be:

physics-General
General
physics-

Twelve conducting rods form the riders of a uniform cube of side 'l'. If in steady state, B and H ends of the rod are at 100°C and 0°C. Find the temperature of the junction 'A’.

Twelve conducting rods form the riders of a uniform cube of side 'l'. If in steady state, B and H ends of the rod are at 100°C and 0°C. Find the temperature of the junction 'A’.

physics-General
parallel
General
physics-

Three rods made of the same material and having same cross-sectional area but different lengths 10cm, 20 cm and 30 cm are joined as shown. The temperature of the joint is:

Three rods made of the same material and having same cross-sectional area but different lengths 10cm, 20 cm and 30 cm are joined as shown. The temperature of the joint is:

physics-General
General
physics-

Three conducting rods of same material and cross-section are shown in figure. Temperatures of A, D and C are maintained at 20°C, 90°C and 0°C. The ratio of lengths of BD and BC if there is no heat flow in AB is:

Three conducting rods of same material and cross-section are shown in figure. Temperatures of A, D and C are maintained at 20°C, 90°C and 0°C. The ratio of lengths of BD and BC if there is no heat flow in AB is:

physics-General
General
physics-

A ring consisting of two parts ADB and ACB of same conductivity k carries an amount of heat H. The ADB part is now replaced with another metal keeping the temperatures T1 and T2 constant. The heat carried increases to 2H. What should be the conductivity of the new ADB part? Given fraction numerator A C B over denominator A D B end fraction equals 3 colon

A ring consisting of two parts ADB and ACB of same conductivity k carries an amount of heat H. The ADB part is now replaced with another metal keeping the temperatures T1 and T2 constant. The heat carried increases to 2H. What should be the conductivity of the new ADB part? Given fraction numerator A C B over denominator A D B end fraction equals 3 colon

physics-General
parallel
General
physics-

The wall with a cavity consists of two layers of brick separated by a layer of air. All three layers have the same thickness and the thermal conductivity of the brick is much greater than that of air. The left layer is at a higher temperature than the right layer and steady state condition exists. Which of the following graphs predicts correctly the variation of temperature T with distance d inside the cavity?

The wall with a cavity consists of two layers of brick separated by a layer of air. All three layers have the same thickness and the thermal conductivity of the brick is much greater than that of air. The left layer is at a higher temperature than the right layer and steady state condition exists. Which of the following graphs predicts correctly the variation of temperature T with distance d inside the cavity?

physics-General
General
physics-

Two sheets of thickness d and 2 d and same area are touching each other on their face. Temperature TA, TB, TC shown are in geometric progression with common ratio r = 2. Then ratio of thermal conductivity of thinner and thicker sheet are

Two sheets of thickness d and 2 d and same area are touching each other on their face. Temperature TA, TB, TC shown are in geometric progression with common ratio r = 2. Then ratio of thermal conductivity of thinner and thicker sheet are

physics-General
General
physics-

The spectral emissive power E subscript lambda end subscript for a body at temperature T1 is plotted against the wavelength and area under the curve is found to be A. At a different temperature T2 the area is found to be 9A. Then lambda subscript 1 end subscript divided by lambda subscript 2 end subscript equals

The spectral emissive power E subscript lambda end subscript for a body at temperature T1 is plotted against the wavelength and area under the curve is found to be A. At a different temperature T2 the area is found to be 9A. Then lambda subscript 1 end subscript divided by lambda subscript 2 end subscript equals

physics-General
parallel
General
physics-

A cuboid ABCDEFGH is anisotropic with alpha subscript x end subscript equals 1 cross times 10 to the power of negative 5 end exponent divided by blank to the power of ring operator end exponent C comma blank alpha subscript y end subscript equals 2 cross times 10 to the power of negative 5 end exponent divided by blank to the power of ring operator end exponent C comma alpha subscript z end subscript equals 3 cross times 10 to the power of negative 5 end exponent divided by blank to the power of ring operator end exponent C Coefficient of superficial expansion of faces can be

A cuboid ABCDEFGH is anisotropic with alpha subscript x end subscript equals 1 cross times 10 to the power of negative 5 end exponent divided by blank to the power of ring operator end exponent C comma blank alpha subscript y end subscript equals 2 cross times 10 to the power of negative 5 end exponent divided by blank to the power of ring operator end exponent C comma alpha subscript z end subscript equals 3 cross times 10 to the power of negative 5 end exponent divided by blank to the power of ring operator end exponent C Coefficient of superficial expansion of faces can be

physics-General
General
physics-

An ice cube at temperature – 20°C is kept in a room at temperature 20°C. The variation of temperature of the body with time is given by

An ice cube at temperature – 20°C is kept in a room at temperature 20°C. The variation of temperature of the body with time is given by

physics-General
General
physics-

Heat is conducted across a composite block of two slabs of thickness d and 2d. Their thermal conductivities are 2k and k respectively. All the heat entering the face AB leaves from the face CD. The temperature in °C of the junction EF of the two slabs is :

Heat is conducted across a composite block of two slabs of thickness d and 2d. Their thermal conductivities are 2k and k respectively. All the heat entering the face AB leaves from the face CD. The temperature in °C of the junction EF of the two slabs is :

physics-General
parallel

card img

With Turito Academy.

card img

With Turito Foundation.

card img

Get an Expert Advice From Turito.

Turito Academy

card img

With Turito Academy.

Test Prep

card img

With Turito Foundation.